Home / E-Flite / E-flite 60-Amp Pro Switch-Mode BEC Brushless ESC V2: EC3

E-flite 60-Amp Pro Switch-Mode BEC Brushless ESC V2: EC3

Quantity
ADD TO CART
BUY IT NOW
  • Detail

    Overview

    The E-flite® 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.

    If you are purchasing this ESC to replace the ESC in your Carbon-Z Cub SS (EFL12450/EFL12475) or the Carbon-Z Cessna 150 (ELF1450/EFL1475) you will need the DYNC0029 adapter

    Key Features

    • Up to 60 amps continuous current with proper air flow and 75 amps burst current (15 seconds)
    • 5A continuous current, 5V switch-mode BEC circuit (proper cooling and airflow required)
    • Stronger BEC for support of most 3-axis stabilization systems
    • Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage
    • 3- to 6-cell Li-Po, 9 to 18-cell Ni-MH/Ni-Cd input voltage
    • Finned heat sinks
    • Programmable motor braking
    • Safe power-arm mode prevents accidental starts
    • Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
    • Programmable throttle input range (1.1ms-1.9ms or 1.2ms-1.8ms)
    • Programmable soft start for helis and airplanes
    • Auto motor shut down if signal is lost or there is interference
    • Programmable timing—5 user-selectable ranges for use with a large variety of brushless motors
    • Utilizes new smaller MOSFET technology to minimize weight
    • Radio system power on/off switch
    • Pre-wired connectors—E-flite® EC3™ connector on battery input and 3.5mm gold bullet connectors on motor output leads

    Product Specs

    Amperage
    60A
    Brakes
    Yes - Programmable
    Connector Type
    EC3
    Input Voltage
    10.8V - 22.2V
    Maximum Burst Current
    15 sec @ 75A
    Output Connector
    3.5mm Bullet
    Part Type
    Electronics
    Programmable
    Yes
    Wire Gauge
    13 AWG
  • Customer Reviews
    No comments
BACK

You May Also Like